Arc Flash Signs

Clarion's arc flash safety signs give those who service your electrical equipment the information they need to avoid potential arc flash explosion hazards.

CATEGORY

1
Results per page
S10032-
Arc flash and shock hazard. Do NOT operate disconnect switch or remove any cover without appropriate PPE.
S10033-
Potential arc flash hazards. Wear proper personal protective equipment while working inside energized cabinet. (See NFPA 70E).
S10034-
Arc flash and shock hazard. Appropriate PPE required.
S10035-
Arc flash and shock hazard. Follow ALL requirements in NFPA 70E for safe work practices and for personal Protective Equipment.
S10038-
Arc flash and shock hazard. Appropriate PPE required. See your supervisor.
S10040-
Arc flash and shock hazard. Follow all requirements in NFPA 70E for safe work practices and for personal protective equipment.
S10044-
Shock & Arc Flash Hazard. This equipment poses a shock and arc flash hazard that may cause severe injury or death. Wear proper protective equipment before opening or performing diagnostic measurements or testing while energized. (See NFPA 70E). Only qualified persons should open or work on this equipment.

1
Results per page

Need Customization?


We can tailor signs and labels to meet your specific needs.


resource-center.jpg


Our expert Compliance Specialists stand ready to design safety warnings that meet your exact requirements. Or select from our stock of standardized U.S. and international safety labels and safety signs.


Stock or custom for you.